top of page

240 SERIES DISC HARROW

Series 240 Double Offset Tandem Disk Harrow - for use with tractors in the 275 – 500 hp range.

Features

  • Four gauge wheel assemblies provide a consistent penetration depth on all four gangs while providing accurate leveling.

  • Double offset tandem disk harrow series is ideally suited to provide excellent uniform tillage results in all plowing applications.

  • Main frame and gang carriers constructed of tough high-strength tubular steel, welded for maximum strength and durability.

  • Transport position allows for approximately 10” (254mm) of ground clearance with standard 24” (610mm) diameter disk blades.

  • Equipped with reliable, heavy-duty, dual tapered 9” (229mm) self-aligning oil-bath gang roller bearings with cast housings.

  • Bearing wear plates help protect the bearing housing from wear caused by abrasive soils, extending their service life and decreasing cost.

  • Up to 8” (204mm) depth of penetration.

  • Tapered gang assemblies mounted on rock flex standards.

Specifications

*Engine horsepower is suggested ranges and varies according to soil conditions and weight added to the scraper.
NOTE: This scraper requires hydraulic control. One rear tractor hydraulic circuit required for scraper operation. Additional hydraulic circuits required for tilt option and each attachment.

Standart Equipment

Optional Equipment

  • 24” (610mm) diameter x 1/4” (6mm) thick, smooth (round) shallow concavity disk blades.

  • Heat-treated alloy steel gang axles.

  • Heavy-duty cast steel spacers.

  • Eight 12.5L x 15 – F1 highway service tires for easy plowing, turning, and transporting.

  • Heavy duty 8 bolt wheel hubs with 2 tapered roller bearings on each hub with moisture protection.

  • Tandem walking beam transport.

  • Four gauge wheel groups.

  • Hydraulic control group includes cylinders, hose holders, and hoses with fittings to reach the rear of the tractor.

  • Hardened pins and bushings on all pivot points.

  • Adjustable disk blade scrapers.

  • Rock flex standards.

  • Drawbar jack stand.

  • 24” (610mm) diameter x 1/4” (6mm) thick, cutout (notched) front and smooth (round) rear shallow concavity disk blades.

  • 24” (610mm) diameter x 1/4” (6mm) thick, cutout (notched) front and rear shallow concavity disk blades.

  • Rear hitch assembly.

  • Rear hydraulic group.

  • Heavy duty bearing wear plates with 1/4” (6mm) hard plate overlay.

  • Light group.

bottom of page